Fabric: the amount depends on the size of your mat. I used about 3/4 yard for my kitchen mat, and 1 1/2 yards for my entryway mat).
Rubber Mat Runner: I’ve seen similar floor mats made with vinyl flooring remnants (check out Diane’s floor mat from In My Own Style!), but I wanted something sturdy with traction and this fit the bill! Found at Home Depot in the flooring section.
4. Determine your fabric placement. Then fold the fabric back about halfway and spray the rubber mat with spray adhesive. Fold the fabric back down, smoothing out the bubbles and wrinkles as you go. Lift the other side of fabric up and repeat that method. The fabric should stick well to the rubber mat.
5. Brush a water-based polyurethane on to your fabric. Make sure it’s water-based so that your fabric doesn’t yellow! This will seal your fabric and protect it from water. You’ll also be able to wipe the mat down should anything spill on it (let’s be honest, I wish I could poly every surface in my house for this reason). I did 3 coats of poly, letting it dry completely in between coats.
6. Once the final coat has dried, lay your mat fabric-side down on the ground. Begin folding the edges of the fabric towards the center of the rubber mat. Spray each edge with adhesive and press down until it sticks. Then take your duct tape and run it along the edges to create a seal. No one will see the underside of your mat and you’ll want the extra security the duct table provides!
To create perfect corners, just follow these simple steps:
1. Grab the corner and fold up towards the center of the mat.
2. Fold one side up flush against the edge of the rubber mat to create a straight line.
3. Fold the opposite side up in the same way until both sides meet in the middle.
Once you’ve finished duct taping, you’re done! Lay your floor cloth down and admire your handiwork. So easy, and so cute! Here’s the one I made for the entryway (It’s 4 feet by 2 feet, if you were wondering):